G2000TGB-1GBG2000TCHAIN SAWOWNER’S MANUALGB848C0593A0 (704)
G2000TGB-106. When engine has ignited, first turn in the choke knobto the first-stage position (2) and then pull the starteragain to start the engine.
G2000TGB-11GB• When the brake operates, release the throttle leverto slow down the engine speed. Continuous opera-tion with the brake engaged will gen
G2000TGB-12 FELLING A TREE1. Decide the felling direction considering the wind,lean of the tree, location of heavy branches, ease ofcompleting the ta
G2000TGB-13GB3. Oil filter1. With a wire hook, take out the oil filter from the feed-ing port.2. Wash the filter with gasoline.When returning the fil
G2000TGB-14 SAW CHAINIt is very important for smooth and safe operation toalways keep the cutters sharp.The cutters need to be sharpened when:• Sawdu
G2000TGB-15GB9. Troubleshooting GuideCase 1. Starting failureMake sure the icing prevention system is not working.Check fuel for wateror substandard
G2000TGB-16Limited warrantyShould any failure occur on the product under normaloperating conditions within the applicable warranty pe-riod, the failed
G2000TGB-2EXPLANATION OF SYMBOLS AND SAFETY WARNINGSContents1. For Safe Operation ...
G2000TGB-3GB1. For safe operation WARNINGThis chainsaw has been especially designed for treemaintenance and should therefore only be used bytrained op
G2000TGB-420. Operate the chain saw only in wellventilated areas. Never start or runthe engine inside a closed room orbuilding. Exhaust fumes contain
G2000TGB-5GBWORKING WITH TREE SERVICE CHAIN-SAWSFROM A ROPE AND HARNESSThis chapter sets out working practices to reduce therisk of injury from tree s
G2000TGB-6Gaining a good footing at the working position can beassisted by use of a temporary foot stirrup created froman endless sling.Starting the s
G2000TGB-7GB2. Explanation of Symbols on the MachineThe port to refuel “MIX GASOLINE”Position: Fuel capThe port to top up chain oilPosition: Oil capSe
G2000TGB-8Open the box and install the guide bar and the sawchain on the power unit as follows:The saw chain has very sharp edges. Use thick pro-tecti
G2000TGB-9GB4.Pour in the rest of gasoline and agitate again for at leastone minute. As some oils may be difficult to agitate de-pending on oil ingred
Kommentare zu diesen Handbüchern