Zenoah G200PU Bedienungsanleitung

OWNER'S MANUALThank you for purchasing a ZENOAH engine. ● Please read this Service Manual thoroughly and use the engine correctly. (For safetyrea

10● Please determine the propeller to use in keeping with the airplane’s size, gross weight, andflight characteristics. If necessary, consult with som

11● Close the choke lever and open the throttle valve 10% to 15%.● Pressing the tip of the starter to the engine’s spinner, press the start switch for

12(A) ADJUSTING THE IDLING● After engine startup, set the idling at about 2000rpm, turn the L needle to the right (toreduce fuel), and search for the

● Different from a glow engine, this engine does not require any special brake in.● After 5~10 tanks (2~3 hours), adjust the carburetor’s L and H need

14To ensure safe use of the engine, make sure of the items specified in the table below.MAINTENANCECylinder, carburetor, muffler, Leakage & breaka

PROPELLER HUB REMOVAL● Remove the propeller hub as specified below.15TIGHTENING TORQUE CHARTTightening TorquePart Screw Size N-m Kg-cm RemarksCylinder

OTHER INFORMATIONThis information is to enable our customers to enjoy radio control airplanes more, but allcustomers must take responsibility if they

KEY# PART NUMBER DESCRIPTIONREMARKSQ'TY/UNIT17PARTS LIST1 848EW08100 CARBURETOR ASSY 12 3306-81380• SCREEN 13 3080-81120• COVER 14 3310-81130• SC

18PARTS LIST

KEY# PART NUMBER DESCRIPTIONREMARKSQ'TY/UNITKEY# PART NUMBER DESCRIPTIONREMARKSQ'TY/UNIT1925 1152-43290 WASHER 126 8488608000 NUT 127 848EW0

2Specifications ...3Safety Precautions ...

20● Scope of ApplicationThis warranty applies only to the engines and parts manufactured by ZENOAH and sold directly or through distributors.● Limit o

3NO. ITEMS SPECIFICATIONS1. Engine model G200PU2. Displacement 20.1cm33. Bore x stroke ø32mm x 25mm4. Weight 990g (not including DC Ignition Unit)5. C

4● These safety precautions are to prevent you and those in the vicinity fromincurring harm or damage. Make sure to observe these precautions and toco

5• Special caution must be taken with all propellers used. Make sure to usethem correctly, in keeping with the manufacturers’ operating manuals, etc.F

6The carburetor, muffler, and air funnelhave not been assembled. Pleaseassemble them correctly, following thediagram shown below.ENGINE ASSEMBLYNo. Pa

71. Make sure to install the power switch.2. Push the sparkplug cap all the way over the sparkplug. (use gloves)3. Fixate the unit within the fuselage

8● For gasoline, please use either regular or high octane, for cars. (The octane number shouldbe 85 or higher.)● For oil, use a high-performing mixed

9● Mount the throttle arm tothe carburetor’s throttleshaft as shown in thediagram or use the throttlevalve stopper plate locatedat opposite side. THRO