Zenoah G3000 Bedienungsanleitung

OWNER/OPERATOR MANUALCHAINSAWS2631-93111(205)The engine exhaust from this productcontains chemicals known to the Stateof California to cause cancer, b

 10  FUELING THE UNIT (OP1)1. Remove the fuel tank cap and pour fuel into thetank up to 80% of full capacity. 2. Fasten the fuel cap securely and w

7. Operation5. While holding the saw unit securely on theground, pull the starter rope vigorously. (OP6)Do not start the engine while hanging the chai

 12  ADJUSTING CARBURETOR (OP9)The carburetor has been adjusted at the factory.Should your unit need readjustment due to thechanges in altitude or

• Before proceeding to your job, read “For SafeOperation” section. It is recommended to firstpractice sawing easy logs. This also helps youget accusto

SA3SA4SA5 14  LOGGING AND LIMBING 1. Always ensure your foothold as well asstability of the tree. 2. Be alert to the rolling over of a cut log. 3.

● Pruning 1. Do not use an unstable foothold or astepladder. 2. Do not overreach. 3. Do not cut above shoulder height. 4. Always use both hands to gri

 16 9. MaintenanceMake sure to stop the engine before inspectingand/or servicing the unit. DAILY MAINTENANCE SAW CHAIN It is one of the essential

9. MaintenanceGUIDE BAR 1. Remove sawdust in the bar groove and theoiling port. (MA5)2. Grease the nose sprocket from the feeding porton the tip of th

 18 OILING PORT Dismount the guide bar and check the oiling portfor blocking by sawdust. (MA9)GENERAL Inspect the entire unit for fuel leakage, Ioos

10. Storage1. Empty the fuel tank and run the engine out offuel. 2. Empty the oil tank. 3. Clean the entire unit. 4. Store the unit in a dry place out

Head Office: 1-9, Minamidai, Kawagoe-city, Saitama, 350-1192 JapanTelephone: (+81)492-43-1117 Telecopier: (+81)492-43-7197PRINTED IN JAPAN

SAFETY FIRSTInstructions contained in warnings within thismanual marked with a symbol concerncritical points which must be taken intoconsideration to

2. Specifications G3000Power unit : Dis placement ···································································································

3. Symbols on the machine 5 For safe operation and maintenance, symbols areon the machine. According to these indications,please be careful not to t

 6 4. For safe operation1. Never operate a chain saw when you arefatigued, ill, or upset, or under theinfluence of medication that may makeyou drows

 7 4. For safe operation16. Operate the chain saw only in wellventilated areas. Never start or run theengine inside a closed room or building.Exhaus

A standard saw unit package contains the items asshown. (SE1)Open the box and install the guide bar and the sawchain to the power unit as follows. The

6. Fuel and chain oil 9  Fuel Mix a regular grade gasoline (leaded orunleaded,alcohol-free) and a quality-proven motoroil for air cooled 2 cycle en